Setting up TV on SAMSUNG

Setting up digital television (DCB-C) using the example of SAMSUNG UE32F6400

 

We go to the TV menu.

 

 

We select the item: "Broadcast".

 

 

 

Then click on "Cable Search Options".

 

 

We set the following parameters:

 

• Beginning frequency - 346000KHz
• End Frequency - 802000KHz
• Baud rate - 6875KS/s
• Modulation - 256QAM

 

 

Press the "Return-Exit" button on the remote control (remote control) and select "Auto-tuning."

 

 

Click "Start".

 

 

Choosing parameters:

• Antenna - Cable;
• Channel Type - Digital;
• Search Mode - Network;
• And press "Scan".

 

 

Upon completion of autotuning, click "Close".

 

 

To display the EPG (Electronic Program Guide) correctly.

 

 

The time needs to be corrected. The current TV time can be viewed by pressing the "GUIDE" button on the remote control. »The current time is shown in the upper right corner of the screen. If it does not correspond to reality, then go to the TV menu.

 

 

We select the item "System".

 

 

Then the item "Time".

 

 

Then "Hours".

 

 

We put the "Clock Mode" in "Auto".

 

 

Then go to the "Time zone" and edit the parameters as in the picture below.

 

 

Checking the status (subscription) of the card

 

If your channels are not shown and there is a message on the screen "Signal is encrypted", "No access" or "No access", then you need to check the "Subscription status". We go to "Menu-> Broadcast-> Common interface".

 

 

Then "Menu CI".

 

 

Then "Subscription status".

 

 

Click "Next entitlement".

 

 

Until "Name: Conax 6" appears.

 

 

Your "current subscription" is displayed here.

 

CONAX SMIT module firmware

 

If your module firmware is lower than 2.8.2.4, then we recommend updating.

 

 

You can view the firmware version on the path Menu -> Broadcast -> Common Interface -> Menu CI -> About Conax CA. Depending on the language of the menu of the module itself, it may be "About Conax CA".

 

 

Firmware. We go along the path Menu -> Broadcast -> Channel settings ->

 

-> "Manual setting" ->

 

 

-> Setting up "digital channels".

 

 

 Click "Create".

 

 

We set the parameters as in the picture below and click "Search".

 

 

Go to viewing mode and find the "Start Service" channel.

At a certain point, a message will appear indicating that there is an updated version of the software and the download will proceed.

"IN THIS DO NOT TURN OFF THE TV AND SWITCH TO OTHER CHANNELS".

Downloading takes about 7 minutes, after the TV will reboot and will work in the same mode.

 

Setup completes.